Gatco 783 Mounting Bracket for Recessed Paper Holders

SO you've got the hole cut out to fit your tp dispenser. You've got to put the tp dispenser screws through the back of the dispenser. Force the screws into the slots on the bracket to make threads. Do not tighten more than a few threads because you'll never get the whole rig into the wall. Then put the bracket into the hole DIAGONALLY with the tp dispenser loosely attached. Carefully turn the whole deal until it fits the right way. Then jiggle it to make sure the spring is properly seated. Using a motoroized screw gun SLOWLY tighten the screws. Make minor alignment adjustments as you tighten. These are the most instructions for this you will see anywhere, including the packaging.

If you don't have an old mounting bracket from an existing recessed holder, you will need to buy this one. If using an existing holder, from a different brand, new holes will need to be drilled. Using Gatco's hardware for mounting a Gatco TP holder is really plug-n-play. Maybe a little pricey, but it does a nice job.

Buy Gatco 783 Mounting Bracket for Recessed Paper Holders Now

Stretch the spring if it does not reach the stud or drywall. Toilet roll holder is installed nice and tight :)

Read Best Reviews of Gatco 783 Mounting Bracket for Recessed Paper Holders Here

It worked exactly as promised I read a few of the other reviews and the suggestions were very helpful especially the one about threading the screws into the bracket before trying to mount it.

I would recommend that you use a little tape to hold the spring connected to the bracket while you're positioning it, I dropped the spring and had to fish it out.

Want Gatco 783 Mounting Bracket for Recessed Paper Holders Discount?

I was able to mount the toilet paper holder without this part so I really did not need it. Otherwise it looks ok.

Save 26% Off