Alsons Corp 2Pk Wht Shwrsplashguard Ps8814 Bath Safety

The small expansion pleat in the center was just enough give to fit the gap between the shower wall and tub. I was unable to locate this type shower splash guard at the local hardware stores.

I originally bought these at a local store which didn't have the adjustable bend in the middle.

They didn't fit our tub the angle were way off so I went online and found these.

I thought these were flexible and would be easy to adjust but were VERY hard and stiff.

So you will need to use a blow dryer and heat it up a bit and then stretch them apart.

After that the angle was good not perfect but good enough that you won't need to put tons of

caulking in the gaps. Just a thin layer and was good for our tub. It has a clip to hold the shower curtain

and depending on which side you are putting it on you will need to take the clip off and put it on the

right side again. I think they should make these like an accordion which would be flexible and easier to

adjust to your tub and the sides with rubber than hard plastic. Then it would probably be perfect.

But for now this will do.

Buy Alsons Corp 2Pk Wht Shwrsplashguard Ps8814 Bath Safety Now